/
Yeastar

Yeastar

Registration

Once you have access to your PBX, log in and navigate to Extensions & Trunks on the left hand side.

image-20260114-110933.png

Select Trunk from the sub header then Add.

image-20260112-144926.png



You should now see the setup screen

image-20260114-121412.png

Fill out the Basic details, ensuring that Trunk Status is set to Enabled
The following settings will not change:

  • Hostname/IP - trunking.byphone.co.uk

  • Domain - trunking.byphone.co.uk

  • Port - 5060

  • Transport - UDP

image-20260114-121552.png

To find your username, go to https://bytrunk.byphone.co.uk/subscriber and search for the Trunk you are going to register to Yeastar

image-20250306-105418.png

Click Show to view trunk settings, follow our trunk settings guide for generating your trunk password -Trunk Settings

When the details are filled out, the setting should look like the below

Click Save & Apply

Outbound Calls

Go to Call Control, then Outbound Route

image-20260114-165018.png

Click Add

image-20260114-165340.png

Name your route, and set the below Dial Pattern
X.
+X.

image-20260114-165609.png

Scroll down, and move the Trunk to the allowed section

image-20260114-165922.png

Scroll down to Extension / Extension Group
Then move users to the allowed list

image-20260114-170513.png
image-20260114-170739.png

Click Save and Apply

 

Inbound Route

Go to Call Control, then Inbound Route

image-20260114-172425.png

Click Add

image-20260123-134919.png

Name the DDI then select which Trunk you want to use

image-20260123-135105.png

Scroll down to DID Pattern and click add and enter the DDI number
The number format should match the inbound route within Bytrunk

image-20260128-102359.png
image-20260128-101743.png
Number Formats within Bytrunk


Scroll down to Default Destination and point the number to it’s destination

image-20260123-135337.png

Click Save

Troubleshooting

There may be times were there are issues with either audio (1 way or no audio both ways), or when making outbound calls to IVRs or calls cutting off.

There is a config change on the Yeastar which is changing the codec settings. Below is a run through of these config changes:

*Log on to Yeastar System and go to Security then security settings and enable SSH.

  • SSH into system using username – support and the password set in security settings.

*type cd /ysdisk/support/customcfg

  • Type vi gncustom.conf

*type a

*when file opens up use direction keys to move curser to [end file] then press enter to create a new line.

*Type /etc/asterisk/pjsip_enpoint.conf

*press esc button

*type :wq to save file

*Type vi pjsip_endpoint_custom.conf

*Type a

*Type [endpoint-basic](!)
adaptive_encoding=no

*Press Esc Button

*Type :wq

 

Close window  and reboot system